Bimetal Thermal Sensor Suitable for Godrej Refrigerator Defrost Bimetal Thermostat with Original Fit Connector Temperature Control & Defrost Protection Heavy Duty & Durable Spare Part

Switch OFF the Power – Unplug the refrigerator or switch OFF the main power supply before starting installation. Access the Evaporator Area – Remove the required inner panel/cover carefully to access the evaporator and existing bimetal sensor. Locate the Existing Bimetal – Identify the old bimetal sensor attached to the evaporator/defrost assembly. Disconnect the Connector – Carefully disconnect the existing bimetal connector from the refrigerator wiring harness. Remove the Old Sensor – Release the clips or mounting arrangement and remove the old bimetal sensor without damaging the evaporator or wiring. Install the New Bimetal – Position the TECHNOVATE bimetal sensor in the same location and orientation as the original sensor, ensuring proper contact with the evaporator/pipe where applicable. Connect the Wiring – Connect the supplied connector securely to the refrigerator's corresponding wiring harness. Secure the Sensor – Make sure the sensor and wires are firmly positioned and cannot interfere with the evaporator fan or other moving parts. Reinstall the Panel – Carefully put the evaporator cover/panel back in its original position. Restore Power – Plug in the refrigerator and switch ON the power supply. Test Operation – Allow the refrigerator to operate and verify that the cooling and defrost system are functioning normally. ⚠️ Important: Always match the bimetal temperature specification, connector, wiring and refrigerator model with the original part before installation. Installation should preferably be performed by a qualified refrigerator technician.